Warning On Installation And Use - Olivetti COPIA 9020 Bedienungsanleitung

WARNINGS ON INSTALLATION AND USE
The environmental conditions affect the correction functioning of the copier. Do not install the
machine in environments which present the following conditions:
• Temperature and humidity that are too high or too low, for example next to a tap, a water heater, a
humidifier, an air conditioner, a radiator or a stove.
• Direct sunlight (if this is unavoidable, make sure that the copier is shaded by a curtain or blind).
• Poor ventilation.
• Environments that are dusty or close to ammoniacal gas emissions, alcohol or solvents.
• Areas subject to vibrations or unstable surfaces.
• Areas subject to rapid changes in temperature. The copier quality could be damaged by condensation
forming on the machine when it is heated up quickly after being stored in a cold environment.
• Near to televisions, radios, computers or other electronic equipment.
Safe power supply
• Connect the copier to a 220/240 V AC wall socket of at least 15 A.
• Use earthed walls sockets, which are easy to access and used only by the copier.
• Place the power supply cable so that it cannot be crushed (damaged cables could cause accidents).
• The general on/off switch is used for operating functions only. To disconnect the copier, unplug of the
power supply cord.
Installation area
• Leave at least 10 cm between the copier and the wall to allow sufficient air circulation.
• Make sure there is enough room around the copier to allow easy access.
Before moving the copier
• The electrical specifications of the copier are indicated on the label attached to the back of the
machine.
If you need to move the machine to another location, check that the electrical characteristics are
suitable. If not, contact your dealer.
Precautions for use
• Do not disassemble or modify the copier.
• Carefully remove staples and clips from original documents to prevent them falling into the copier.
• Take great care when operating in the fusing area, which may be very hot.
• Do not switch off the copier or open the front panel while copies are being made, as this may case
paper jams.
• Do not use aerosol sprays near the copier.
• If the copier fails to function properly, refer to the chapter on Operator Troubleshooting. In most cases,
you will be able to resolve the problem yourself. If you cannot, switch off the copier, remove the power
supply cord from the socket and call the Technical Assistance Service.
• The manufacturer declines any responsibility in the case of misuse, improper installation, connection
to unauthorized equipment, use of non-original accessories, tampering by unauthorized persons.
chap1.p65
Downloaded from www.Manualslib.com
1
manuals search engine
01/02/00, 10.41
1