Troubleshooting - Epson TM-J7000 Bedienungsanleitung

Disposal of Used Cartridges
Dispose of used ink cartridges as industrial waste products. Observe the laws and
regulations of your country and district.
Ink Cartridge Life
To make your ink cartridges last as long as possible, follow these simple rules:
❏
❏
❏
❏

Troubleshooting

ERROR LED is flashing or lit
❏
❏
❏
❏
Cleaning
If printing becomes faint or uneven and the INK OUT LED is not on or flashing,
press the CLEANING button until the printer mechanism begins to clean the print
head (more than 3 seconds). The POWER LED flashes during cleaning. When the
cleaning stops, the printer is ready for normal printing.
Note:
Do not use the CLEANING button unless there is a problem with print quality.
Unnecessary cleaning will waste ink.
Do not turn off the power or open any covers while the POWER LED is flashing. If you
turn off the power during cleaning and turn on the printer again, a noise will occur due to
a carriage movement, but this is not a problem with the mechanism. Please be sure to wait
until the cleaning is complete (the POWER LED is off.)
Message for Replacing Mechanical Unit
The following message will be printed every time the printer is turned on when
the pump unit is near the end of its life. Please follow the instructions in the
message.
Downloaded from www.Manualslib.com
Do not turn off the power supply switch immediately after printing is completed.
Do not remove an ink cartridge unless you are replacing the cartridge.
Do not turn the printer on and off unnecessarily.
Do not press the CLEANING button unless the print is faint or uneven.
The print head temperature may be high or low. Wait until the print head cools
or warms and the printer resumes printing automatically.
Make sure that the printer cover is properly closed.
If a paper jam has occurred, open the roll paper cover or the ink cartridge cover
and remove the jammed paper. Do not pull the jammed paper by force or use
tools. Be sure to remove it manually.
Turn off the power, wait several seconds, and then turn it on again. If the error
remains, contact your supervisor or a qualified service person.
Caution: The pump unit must be replaced.
Contact a qualified service person.
TM-J7000/J7100 – TM-J7500/J7600 User's Manual 9
manuals search engine
English