Pre-Installation Requirements; Routine And Special Maintenance - glass 1989 AZULEJO SHOWER Installations-, Bedienungs- & Wartungsanleitung

EN
hot. Use water with a maximum temperature of 38°C.
This product is not intended to be used b persons (including
children) with reduced ph sical, sensor or mental capabilities
or lack of experience or knowledge, unless the have been
given appropriate supervision or instruction concerning use
of the appliance b a person responsible for their safet .
W NIN : children ma use the product unsupervised onl
when its operation has been clearl explained to them and
the are able to use it safel while recognising the dangers
of misuse.
All measurements are in mm.

PRE-INSTALLATION REQUIREMENTS

To prevent damaging the mixer parts, place a lter upstream of
the mixer.
T CHNIC L INF M TI N:
Minimum ow pressure:
perating pressure:
ecommended operating pressure:
Hot water temperature:
The product's supporting structure is metallic.
ground s stem is therefore required, with sensitivit meeting
the relevant standards.
GROUNDWIRE.
The ground wire must be connected and xed permanentl
to the electrical s stem.
EQUIPOTENTIAL CONNECTION.
The equipment must be connected to the equipotential
s stem of the room and dul fastened to its terminal to be
found in the product.
The following accessories
manufacturer) are re uired for installation:
a) Fittings to connect the mixer to the domestic water mains
(connection to mixer via ½" ttings).
ROUTINE AND
SPECIAL MAINTENANCE
Use water up to a maximum of 60°C to maintain the shine of the
product over the ears.
Use a soft sponge dampened with water and non-abrasive
neutral liquid detergents
for cleaning.
After cleaning, rinse thoroughly with plenty of water to
remove all traces of detergent and dry with a soft cloth.
A :
VOID
– cleaning materials which contain h drochloric acid, formic acid,
bleach or acetic acid, as the can cause considerable damage.
– s nthetic bre cloths, scouring pads, metal pads, abrasive
detergents, alcohol, acids for domestic use, acetone or other
solvents which damage the surface.
–the build-up of limescale b cleaning regularl .
IMPORTANT:
esidues of toiletries such as liquid soaps, shampoos and shower
gels, hair d es, perfumes, aftershave and nail varnish can also
cause damage.
Rinse thoroughly with plenty of water to remove all traces
of detergent.
Limescale can be removed from water jet nozzles simpl b
rubbing.
150 kPa (1,5 bar)
350 kPa (max 3,5 bar)
250 kPa (2,5 bar)
max 60°C
n ef cient
(not supplied by the
TROUBLESHOOTING
In the event of abnormalities run the following checklist.
All hydraulic connection checkup must be performed by a
hydraulic installation technician.
If the water is slow to drain awa , check that the drain is not
blocked.
If the product does not dispense water, check that:
- There is water in the main pipe.
- The diverter is correctl set.
- There are no impurit into the pipes that prevent normal
water ow.
If the above operations do not solve the problem, contact our
nearest service centre or the compan .
10