Installation; Water Connection - Electrolux ESF2430 Benutzerinformation

Water supply pressure
Capacity

Installation

Warning! Make sure that mains plug is
disconnected from the mains socket
during installation.
Fitting the appliance
Put the appliance adjacent to a water tap and
a drain.
When you put the appliance in place, make
sure that the water hoses are not kinked or
squashed.
Install the appliance on a kitchen sink, work-
top or built-in..
Positioning
Install the dishwasher into the furniture of the
kitchen.

Water connection

Inlet hose
The appliance has safety features to prevent
that the water in the appliance goes back into
the drinking water system.
Connected the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative sour-
ces of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
Minimum
Maximum
Make sure that the dimensions of the recess
agree with the given dimensions.
Make sure that there are openings in the fur-
niture for the inlet hose, the water drain hose
and the mains cable.
Adjusting the level of the appliance
Make sure that the appliance is level to close
and seal the door correctly. If the level of the
appliance is correct, the door does not catch
on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the ad-
justable feet until the appliance is level.
aeolian), use a hot water supply to decrease
energy consumption.
It is important that a water tap or stopcock is
near the dishwasher with easy access.
Connect the inlet hose to a water tap with an
external thread of 3/4".
electrolux 13
0,8 bar (0,08 MPa)
10 bar (1,0 MPa)
6 place settings