Connections, Operating And Display Elements; Channel Display; Level Indicator - LD Systems U300 Serie Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

RECEIVER
2
9
POWER
1
On/off switch. Press and hold the button for approximately 1 seconds to turn the device on or off.

CHANNEL DISPLAY

2
Illuminated LC display to show the radio channel.
3 CHANNEL + / -
Push buttons to select the radio channel 01 to 12. To establish a wireless connection between the transmitter and the receiver, the radio frequency
on both receivers must match (synchronisation process as described under point 6. ASC).
Note: Both receivers cannot be set to the same radio channel on the twin receiver.
4 VOL
Rotary knob to adjust the output volume.
IR INTERFACE
5
Infrared interface for synchronising the receiver's radio channel with the transmitter.
ASC
6
To synchronise the transmitter with the radio channel set in the receiver, position the infra-red port of the transmitter directly in line with the infra-red
interface of the receiver and switch on the transmitter and receiver (distance about 10 cm, IR interface of the hand transmitter is below the status LED,
IR interface of the pocket transmitter on the front side). Now press the ASC button to start the synchronisation process. A red LED indicator will light up
in the window of the IR interface during the process. After a few seconds, the process is completed and one of the LED indicators ANTENNA A and B will
light up (= wireless connection exists).

LEVEL INDICATOR

7
5-segment LED chain to display the audio signal level.
6
3 7 4
5
8
6
3 7
1 2
9
8
4 3 7
2
8
5 4
9
6
5
1
9
6