Lubrication; Blades - VOSS.farming easyCUT pro Bedienungsanleitung

clipper only for clipping horses and other equine breeds. Especially the use on humans is
strictly forbidden. The clipping machine should be inaccessible to children.
Other hazards
If there are dangers and risks during operation which are not linked directly to the clip-
ping of the animals, please let us know. This also applies to technical defects which cause
danger.
tighten
at most and start clipping. If the result is not satisfactory, adjust the tension between the
blades slightly. If the following result is still not good, your blades are probably dull.
If the tension between the blades is too low then hairs accumulate between them,
16

3. LUBRICATION

Lubrication is essential for a good result.
It also prevents overheating and signifi-
cantly prolongs the life of the machine and
the blades. For this purpose, a thin film of
oil must always be present on the moving
parts of the head.
Drip the oil every 10 minutes onto the bla-
des and into the opening as shown in the
pictures. Make sure that both elements do
not run dry under any circumstances.
Please only use special clipping machine
oil for this purpose.

4. BLADES

loosen
Caution: Before making any adjustments
to the blades, make sure that your machi-
ne is switched off and disconnected from
the power supply. Always pull the plug of
your clipper out of the socket.
4a. Adjusting the blades correctly
Before clipping: Adjust the tension nut
(see picture) while the clipper is switched
off. Turn the nut until first resistance is
felt. Afterwards, rotate another ¼ of a turn