Electrical Connection - AGP DM6D Betriebsanleitung

INTRODUCTION
The machine is equipped with spirit levels which aid in aligning the tool. Use the Bull's Eye Level for vertical
aligning and the Tubular Level for horizontal aligning.
This machine is for the intended purpose of diamond core drilling of concrete, masonry, stone and similar
materials. The machine may be hand-held for drilling up to 80mm. For sizes above 80mm, it must be mounted
on a rig (drilling stand). The rig is not included.
All other uses which are not for the intended purpose are prohibited.
It is equipped with a water feed system which is required for the diamond core drilling process.
Convertible models also have two adaptor heads: one for water feed and one for through-the-spindle dust
aspiration. It is equipped with a PRCD interrupter (portable residual current device) which must be used at all
times. It is equipped with a three speed mechanical gearbox for different core drill size ranges and features a
mechanical safety clutch.
The motor has electronics for soft start, overload protection and thermal (overheating) protection. There is an
indicator light on the machine to alert the operator of load and temperature conditions.

ELECTRICAL CONNECTION

The network voltage must conform to the voltage indicated on the tool name plate.
Under no circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Center. Do not try to repair the
damaged cable yourself. The use of damaged power cables can lead to an electric shock.
WARNING:
This machine is equipped with a Portable Residual Current Device (PRCD) also known as a Ground Fault
Circuit Interrupter (GFCI). Always use this device whenever using the machine to reduce the risk of
shock hazards. Test and reset the PRCD device before each use. Press the "Test" button to test. Press the
"Reset" button to energize the circuit.
WARNING!: 110V UK machines are not equipped with a PRCD
portable residual current device or GFCI ground fault circuit
interrupter. The machine must always be used with an isolating
transformer for protection in case an electrical fault should
occur.
Use an RCD in a separate control box with one or more socket
outlets in accordance with EN 60309-2 with the earthing contact
position 1 h.
ASSEMBLY
1.
Mount the handle clamp of the side handle onto the gearbox neck. Position the side handle perpendicular
to the main handle. Use the lock screw to tighten the clamp.
2.
Thread the water supply assy. Into the hole in the bottom of gearbox and tighten with a wrench.
GB
Reset Button
6
On Lamp
Test Button