Electrical Connection - AGP DMS Bedienungsanleitung/Sicherheitshinweise

It is equipped with a PRCD interrupter (portable residual current device) which must be used at all times. It is
equipped with a two speed mechanical gearbox for different core drill size ranges and features a mechanical
safety clutch. The motor has electronics for soft start, overload protection and thermal (overheating)
protection.

ELECTRICAL CONNECTION

The network voltage must conform to the voltage indicated on the tool name plate.
Under no circumstances should the tool be used when the power supply cable is damaged. A damaged
cable must be replaced immediately by an authorized Customer Service Center. Do not try to repair the
damaged cable yourself. The use of damaged power cables can lead to an electric shock.
WARNING:
This machine is equipped with a Portable Residual Current
Device (PRCD) also known as a Ground Fault Circuit Interrupter
(GFCI). Always use this device whenever using the machine to
reduce the risk of shock hazards. Test and reset the PRCD
device before each use. Press the "Test" button to test. Press the
"Reset" button to energize the circuit.
WARNING!: 110V UK machines are not equipped with a PRCD
portable residual current device or GFCI ground fault circuit interrupter. The machine must always be
used with an isolating transformer for protection in case an electrical fault should occur.
Use an RCD in a separate control box with one or more socket outlets in accordance with EN
60309-2 with the earthing contact position 1 h.
ASSEMBLY
1. Mount the handle clamp of the side handle onto the gearbox neck. Position the side handle perpendicular
to the main handle. Use the lock screw to tighten the clamp.
2.
Thread the water supply assy. Into the hole in the bottom of gearbox and tighten with a wrench.
LIST OF CONTENTS
• Diamond core drilling machine.
• Side handle assembly
• Water feed assembly
• Wrench
OPERATING INSTRUCTIONS
1) MOUNTING THE CORE BIT
CAUTION: Ensure that the threads of the spindle and the core bit match. Attempting to mount
mismatched threads will result in damage to both threads.
GB
Reset Button
6
On Lamp
Test Button