Pando PI3100 Gebrauchsanweisung Seite 63

* don't use the [
V) First step : cancel the existing configuration
1) Press the touch n°2 and hold down
2) The symbol [ - ] will appear on each display
3) With your other hand, press successively and
quickly (less than 2s) on each [ - ] display.
Begin from the front right side and turn contrary
clockwise, as described on the picture
(from a to c).
A double "beep" means an error occured. If so, start again from item 1).
4) Remove your fingers from the touch control, then push again on touch 1 during few
seconds, until blinking [ E ] symbols appear.
5) Wait until [ E ] symbols stop blinking.
6) After few seconds, [ E ] are automatically transformed in [ C ]. The existing setup
has been cancelled.
VI) Second step : new setup
1) Use a ferromagnetical pot with a minimum diameter of 16 cm
2) Select a cooking zone by pushing on the corresponding [ C ] display
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected cooking zone is now
configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off.
Please use the same pot for the whole procedure.
Never put several pots together on the zones during the setup-process.
• If [ E 4 ] displaying remains, please call the customer care
The control panel displays [
• An object or liquid covers the control keys. The symbol disappears a soon as the area is
cleaned or the object has been removed.
The control panel displays [ E2 ] or [ E H ] :
• The hob is overheated, let it cool and then turn it onagain.
The control panel displays [ E3 ] :
• The pan is not adapted, change the pan.
The control panel displays [ E6 ] :
• Defective electrical network. Control the frequency and voltage of the electrical network.
The control panel displays [ E8 ] :
• The air inlet of the ventilator is obstructed, release it.
The control panel displays [ E C ] :
• Configuration error. Set the table again, referring to the chapter "The [E 4] symbol
appears."
A slight "click click" sound is heard when placing a container on a stove:
•
This sound is normal. It is a safety indicator to detect the presence of the container on the
inductor. It is automatically activated when the hob is turned on and during cooking.
If one of the symbols above persists, call the Customer Service.
] touch
] or [ Er03 ] :
17