AKG MicroMic C516 ML Bedienungsanleitung Seite 20

a) Using screws:
Fig. 5: Inserting the
reduce mechanical
b) Mounting the
microphone with
flat surface or...
c) on an uneven
20
Downloaded from www.Manualslib.com
3 Using Your Microphone
1. Depending on the material and thickness of the
2
rubber plate to
noise.
Refer to fig. 5. 2. Insert the screws (1) into the openings in the in-
3. Place the non-adhesive rubber plate (3) on the
4. Screw the installation plate (2) on the instru-
Important! • To maintain the mechanical-noise attenua-
• Remove the backing paper from both sides of
no screws on a
• Use the supplied adhesive putty instead of the
surface:
manuals search engine
installation surface, use the 13-mm (0.5-in.)
wood screws or the 30-mm (1.2-in.) machine
screws and nuts.
3
stallation plate (2).
installation plate (2), making the screws engage
the locating holes (4) in the rubber plate (3).
ment or speaker.
tion of the rubber plate, do not tighten the
screws hard enough to squeeze the rubber
plate.
the rubber plate and press the rubber plate
firmly on the bracket and then on the instru-
ment or speaker.
rubber plate.
4
AKG C 516 ML