Interfacing - AKG D5 Bedienungsanleitung

BDA D 5-Hex-XP7:BDA_A6_2006
The microphone provides a balanced output on a
3-pin male XLR connector:
Pin 1: ground
Pin 2: hot
Pin 3: return
You can connect the microphone either to a bal-
anced or an unbalanced microphone input.
• To connect the microphone to a balanced input
(XLR connector), use a commercial XLR cable.
• To connect the microphone to an unbalanced
microphone input (1/4" jack), use a cable with a
female XLR connector and a 1/4" TS jack plug.
Please note that unbalanced cables may pick
up interference from stray magnetic fields near
power or lighting cables, electric motors, etc.
like an antenna. This may cause hum or similar
noise when you use a cable that is longer than
16 feet (5 m).
AKG D 5/D 5 S
12/4/06 1:51 PM

2 Interfacing

Seite 15
15