Recovery Water Tank Emptying; Solution/Clean Water Tank Emptying; After Using The Machine - Viper AS6690T Kurzanleitung

QUICK START GUIDE

Recovery water tank emptying

Stop the machine.
1.
Lift the brush/pad-holder deck (25, Figure 1) by pressing the one-button
2.
start (49, Figure 3) or restart the machine by Ignition key (42, Figure 3).
Lift the squeegee (11, Figure 1) with the squeegee lifting/lowering
3.
handle (39, Figure 2).
Drive the machine to the appointed disposal area.
4.
Empty the recovery water tank with the hose (A, Figure 17). Then, rinse
5.
the tank (B, Figure 16) with clean water.
CAUTION!
When draining the wastewater, the vacuum tube for
waste must be folded (A, Figure 17) and lowered to a
lower position (B, Figure 17), and then open the lid of
the vacuum tube for waste to drain the water. Do not
make the outlet of the vacuum tube for waste face up-
ward to drain the water vertically. This is to avoid
wastewater spilling onto the operator.

Solution/clean water tank emptying

Empty the solution tank with the outlet cover (A, Figure 18). After
1.
working, rinse the tank with clean water.

AFTER USING THE MACHINE

After working, before leaving the machine:
Remove the brushes/pad-holders by pressing the release button (44,
1.
Figure 3) and clean them (only for disc machine).
Remove the splash guard as (E, Figure 19) and cleaning it. (only for disc
2.
machine)
Remove the Pad and clean it. (only for orbital machine)
3.
Empty the tanks (B and C, Figure 18) as shown in the previous
4.
paragraph.
Perform the daily maintenance procedures (see the Maintenance
5.
chapter).
Store the machine in a clean and dry place, with the brushes/ pad-holders
6.
and the squeegee lifted or removed.
16
ENGLISH
Figure 17
C
D
A
Figure 18
E
Figure 19
B