Installing And Adjusting The Squeegee; Filling The Solution Tank - Viper AS710R Bedienungsanleitung

USER MANUAL
8. Check that the water valve (D2) is not indicated "0".
INSTALLING PAD DRIVER OR BRUSH
1. Ensure that the machine is turned off (E5).
2. Raise the brush head (A7) off the floor by trampling the front of foot pedal (A10) on the left
of machine.
3. Put brushes (A8) below both driver motor hub.
4. Lower the brush head (A7) assembly by trampling the rear of foot pedal (A10). And sitting on
the machine to start brush switch (E3). Lightly depress driver pedal (C6), then brushes
automatic installed. If installation cannot be performed successfully in one shot, turn off brush
switch (E3) and reset the suit position to install brushes.
5. Adjusting the nut (A6) to properly place for work.
Never work without the brusher/pad perfectly installed.
When cleaning or replacing the brushes, you should raise the brush head and rotate the
reverse direction to "working" direction quickly. The two brushes are reverse in
direction.

INSTALLING AND ADJUSTING THE SQUEEGEE

1. Ensure that the machine is turned off (E5).
2. Turn the squeegee lift lever (C5) to put down the squeegee bracket (A5) on floor.
3. Loosen the two knobs (B2) on the squeegee and slide the squeegee into the slots in the back of
the squeegee bracket.
4. Tighten the knobs(B2) securely.
5. Secure the vacuum hose (B3) on the pick-up tube of the squeegee.
6. Adjusting the nut (B1) to properly place for suction.
1. It can be filled in water use a hose under the seat (C4).
2. Do not overfill the solution tank. Leave at least two inch from the opening of tank.
3. Water temperature should not exceed 40°C.
Depress the front,
Brushes up

FILLING THE SOLUTION TANK

9
ENGLISH
Depress the rear,
Brushes down