Cameo OPUS H5 Bedienungsanleitung Seite 6

3 FUSE
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated
fuse failure, please contact an authorised service centre.
4 DMX IN
Male 3-pin and 5-pin XLR sockets for connection to a DMX control device (e.g. DMX console). Only use the ports alternatively.
DMX OUT
5
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal. Only use the ports alternatively.
NET IN
6
RJ45 network connector for connecting to an Art-Net or sACN network. Use CAT-5e or better cables to set up the network.
NET OUT
7
RJ45 network connector for connecting additional Art-Net or sACN-capable devices to the network. Use CAT-5e or better cables to set up
the network.
ANTENNE FOR W-DMX™
8
The antenna for control via W-DMX™ remains in the holder (= operating position) during operation.
12
PRESSURE SENSITIVE LC DISPLAY WITH ILLUMINATION
9
Thanks to the pressure-sensitive LC display, the device can be operated directly from the display (glove-compatible). The display shows
the currently activated mode (main display), the menu items in the main menu and sub-menus and the numerical value or status in certain
menu items. If there is no control signal to the device, the display starts flashing; the flashing stops as soon as a control signal is available
(W-DMX, DMX and slave operation, ArtNet and sACN).
ROTARY-PUSH ENCODER
10
Rotary-push encoder for navigating in the editing menu, adjusting system settings and changing values and status in the corresponding
menu items.
Starting from the main display, press the encoder to enter the main menu. Select the individual menu items in the main menu (Control,
Settings, Info, etc.) and in the sub-menus by turning the encoder and confirm the selection by pressing the encoder. Change the value or
status in a menu item by turning the encoder and confirm the change by pressing the encoder.
11 BACK
Briefly press BACK to go up one level in the menu structure. To go directly from the sub-menus to the main display, press and hold the BACK
button for about 2 seconds.
6
11
9
10