Cameo OPUS H5 Bedienungsanleitung Seite 12

See the table below for information on the sub-menu items in the W-DMX menu and the relevant setting options.
Protocol WDMX
Select by turning the encoder, confirm by pressing, change value or status by turning, confirm by pressing. Back with BACK.
DMX Address Setting the DMX start address
DMX Mode Selecting the DMX mode
Receive Activate (On) and deactivate (Off) W-DMX
Reset = Terminate the connection to all paired W-DMX transmitters and put them on pairing
standby
OPERATION VIA ART-NET PROTOCOL
Starting from the main display, press the rotary-push encoder to enter the main menu. Select the Control menu by turning and pressing the
encoder. By turning the encoder you can now select the menu item Protocol, confirm by pressing the encoder and then select ArtNet by
turning the encoder and confirm by pressing the encoder.
See the table below for information on the sub-menu items in the W-DMX menu and the relevant setting options.
Protocol Art-Net
Select by turning the encoder, confirm by pressing, change value or status by turning, confirm by pressing. Back with BACK.
DMX Address Setting the DMX start address
DMX Mode Selecting the DMX mode
Universe Group Setting the Universe Group
Universe Setting the universe
IP Address Setting the IP address: 1. Set block, confirm, set 2nd block, confirm ...
Subnet Mask Adjustment of the subnet mask: 1. Set block, confirm, set 2nd block, confirm ...
W transmitter Activate (On) or deactivate (Off) forwarding of the DMX signal via W-DMX
Establish (Linking) or release (Unlink) a connection to other W-DMX devices.
W-DMX standard Setting the W-DMX standard (G3 / G4s)
DMX XLR Out Forwarding the control signal via XLR Out Activate (On) and Deactivate (Off)
12
001–512
29ch/36ch
On
Off
Reset
001–512
29ch/36ch
000–127
000–255
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
On
Off
Linking
Unlink
G3
G4s
On
Off