Replacing The Power Cable; Disposal And Recycling; Cleaning, Maintenance And Ordering Of Spare Parts - EINHELL RHP 2000 Originalbetriebsanleitung

Anleitung_RHP_2000_SPK7:_
Waxing and de-waxing of skis.
Caution: Intensive heating means a higher risk of
fire and explosion! Ensure good ventilation.
Harmful and/or toxic gases and vapors may be
emitted.
6.3 Selecting the right nozzle
The heat nozzle (4) is designed to protect e.g.
glass panes from overheating by diverting the
hot air. For removing paint.
The wide nozzle (5) provides uniform air
distribution on small surfaces
The reducer nozzle (6) provides a targeted jet of
heat for corners and for soldering work.
The reflector nozzle (7) is designed for soldering
and shaping tubes, for defrosting water pipes
and for shrinking insulating hoses.

7. Replacing the power cable

If the power cable for this equipment is damaged, it
must be replaced by the manufacturer or its after-
sales service or similarly trained personnel to avoid
danger.
8. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
8.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
10.08.2011 15:39 Uhr Seite 11
8.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
10. Storage
Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.
GB
11