Medema Mini Crosser M2 Wartungsanleitung Seite 65

Medema Production A/S
Code Description
1C10 Motor negative current trip
1C12 Reverse overcurrent trip
1E08 Inhibit active
1E09 Inhibit active
1E0A Inhibit active
2100 Programming corrupted
2A12 Forward overvoltage trip
2A10 Motor positive voltage trip
2B10 Motor negative voltage trip
2B12 Reverse overvoltage trip
2C00 Battery Voltage Trip
2E00 Main loop ran out of time
2F01 Throttle displacement trip
3100 Voltage on Bridge too low trip
3201 Internal Processor trip
3240 Firmware corrupted trip
3600 Watchdog trip
3601 Watchdog trip
3612 Watchdog trip
3A00 Programming corrupted
3B01 Open circuit Motor Trip
3D02 Motor output trip
3D03 Motor output trip
Wartungsanleitung P9-0157-S
Action Bars Comments
Trip 8 Possible controller Fault
Trip 8 Possible controller Fault
Note 1 Note 2 Note 1 - trip or speed limit depends on
programming
Note 2 - trucharge display depends on
programming
Note 1 Note 2 Note 1 - trip or speed limit depends on
programming
Note 2 - trucharge display depends on
programming
Note 1 Note 2 Note 1 - trip or speed limit depends on
programming
Note 2 - trucharge display depends on
programming
Trip 8 Possible Controller Fault
Trip 8 Possible Controller Fault
Trip 8 Possible Controller Fault
Trip 8 Possible Controller Fault
Trip 8 Possible Controller Fault
Trip 1 Battery Voltage has dropped below the
operating limits.
Trip 8 Possible Controller Fault
Trip 7 Only trips if "Throttle Operated at Power-Up"
is programmed to "Trip" as recommended
by MDA. Indicates throttle was displaced
when unit was switched on. Check throttle
operation.
No Ripple If "Throttle Operated at Power-Up" is
programmed to "Inhibit" then trucharge
display will ripple up and down until throttle
is reset to neutral. No trip will occur in this
mode. Check throttle operation.
Trip 8 Possible Controller Fault - Can also occur if
keyswitch is on, when battery connections
are connected to Battery terminals or
keyswitch is not operating correctly.
Trip 8 Possible Controller Fault
Trip 8 Possible Controller Fault
Trip 8 Possible Controller Fault
Trip 8 Possible Controller Fault
Trip 8 Possible Controller Fault
Trip 8 Possible Controller Fault
Trip 2 Check Motor connections and motor
components for open circuits. This will not
occur if the "Brake Fault Detect" is disabled.
Trip 3 Motor output is shorted high, possibly to
Battery positive. Check motor connections
and motor components.
Trip 3 Motor output is shorted low, possibly to
Battery negative. Check motor connections
and motor components.
65 von 68 Version 1.0.0/2010