Standard Equipment; Machine Assembly; Mounting Guide Hose To K-40 - RIDGID K-40 Bedienungsanleitung

Drum
Guide Hose
Figure 2 – K-40 AF Drain Cleaning Machine
Motor:
Type ...........................Induction
Rating.........................120V, 1.5A, 50/60Hz
220-240V, 0.9A, 50/60Hz
Toggle Switch.............FORWARD/OFF/REVERSE
Operating Speed..........320 RPM
K-40 Weight
w/C-13IC-SB Cable ......30 lbs.
K-40 AF Weight
w/C-13IC-SB Cable ......33 lbs.
Sound Pressure (L )* ......64.9 dB(A), K=3
PA
Sound Power (L )*...........68.0 dB(A), K=3
WA
* Sound measurements are measured in accordance with a standardized test per
Standard EN 62841-1.
- Sound emissions may vary due to your location and specific use of these tools.
- Daily exposure levels for sound need to be evaluated for each application
and appropriate safety measures taken when needed. Evaluation of expo-
sure levels should consider the time a tool is switched off and not in use. This
may significantly reduce the exposure level over the total working period.

Standard Equipment

All K-40 Drain Cleaning Machines come with one pair of
RIDGID Drain Cleaning Gloves.
This machine is made to clean drains. If prop-
NOTI E
erly used it will not damage a drain that is in good
condition and properly designed, constructed and main-
tained. If the drain is in poor condition, or has not been
properly designed, constructed and maintained, the drain
cleaning process may not be effective or could cause
damage to the drain. (The best way to determine the
condition of a drain before cleaning is through visual in-
spection with a camera.) Improper use of this drain
cleaner can damage the drain cleaner and the drain.
This machine may not clear all blockages.
278-104-281.08_REV. B
FWD/OFF/REV
Switch
GFCI
Foot Switch
AUTOFEED
K-40 Drain Cleaning Machine

Machine Assembly

WARNING
To reduce the risk of serious injury during use, fol-
low these procedures for proper assembly.

Mounting Guide Hose To K-40

1. If required, attach bracket to K-40 frame with
provided (See Figure 3). Do not over tighten bolts.
Guide Hose Plunger Pin
1/4" Bolt
Figure 3 – Mounting Guide Hose to K-40
2. Pull approximately five feet of cable from the K-40.
Insert the cable into the guide hose (the end with the
plunger pin) and feed it through the guide hose until
it reaches the AUTOFEED. Fully lift the levers of the
AUTOFEED and feed the end of the cable through
the end of the AUTOFEED. See Figure 4.
3. Attach the guide hose to the bracket on the K-40. Pull
plunger pin out and place over bracket, making sure
that the plunger pin engages with the hole in the
bracket. See Figure 4.
Figure 4 – Feeding Cable Through AUTOFEED
1 / " bolts
4
Bracket
5