Troubleshooting - Spokey AURIS Bedienungsanleitung

SAFETY KEY
A safety key is intended to deactivate the treadmill immediately if you fall
down. It serves as an emergency stop. The safety key must be used in
urgent cases only.
For safe and convenient stop, use START/STOP button until the treadmill
stops completely. Once you have pressed START/STOP, the treadmill belt
will gradually decreased its speed. The treadmill will not activate until you
ACTIVATION
Connect the plug to the socket, the counter display turns on and the track
goes into standby mode.
BUTTON FUNCTIONS
START/STOP press to start the training or a chosen programme. 3
seconds after the start, the running belt will start moving at the lowest
possible speed or at the speed corresponding to a chosen programme.
Press to stop the training. The treadmill will be slowing down until it stops
completely.
SPEED +/- - in sleep mode used to set values. While in operation, pressing
the buttons increases / decreases the speed by 0.1 km/h. Pressing the
DISPLAY INFORMATION
SPEED: current speed.
TIME : workout time.
MEASUREMENT RANGE
Speed – adjustable between 0 and 16 km
QUICK START (MANUAL MODE)
In the manual mode you can set the speed while running by pressing the
speed adjustment buttons (SPEED).

TROUBLESHOOTING

Error or error code
Display not show
Display not complete
Running belt not smooth,shaking
Display show" ---" E00/E07
E01/E13
E02
E04
COUNTER
Reason
A. no power
B. power switch not on
C. pcb no power
D. computer wire broken
E. computer broken
F. back ground light not on
A. display IC not well welded
B. conductive bar not well fixed
C. display IC broken
A. motor has resistance
B. motor belt too tight
C. pcb torque too small or too big
A. no safety key
B. magnetron not well fixed
A. signal wire not well connect
B. signal wire broken
C. computer wire broken
D. pcb signal wire broken
A. motor wire not well connected
B. IGBT broken on pcb
C. input voltage too low
A. incline motor wire not well connected
B. incline motor broken
have inserted the safety key in the key hole located in the centre of the
counter control desk, which provides additional protection to treadmill
activation by third parties. The other end of the key must be attached to
clothes. If you fall down, the safety key will fall out the control desk and the
treadmill will stop immediately. Use only in urgent situations
SLEEP MODE
After 10 minutes of inactivity, the track goes into sleep mode and the
counter is turned off. Press any button to resume the track.
button for more than 5 seconds will make the value increase/decrease in
continuous mode.
Incline +/- - in sleep mode used to set values. While in operation, pressing
the buttons increases/decreases the inclination angle by 1 level. Pressing
the button for more than 5 seconds will make the value increase/decrease
in continuous mode.
Incline: inclination angle of the treadmill belt during workout. .
The training starts 3 seconds after pressing START button and stops after
pressing STOP button.
Solution
Connect the power
Turn on power switch
Press over-load key or change new pcb
Change new wire
Change new computer
Check the wire or change new
Re-welded it.
Re-fix it.
Change new IC.
Adjust motor or add some lubricate oil.
Adjust motor belt
Adjust pcb torque to suitable position
Put safety key
Fix it well.
Re-connect it
Change new one
Change new computer
Change new pcb
Re-connect it
Change new pcb
Stop using and ask electrician to repair.
Re-connect it.
Change new one
19
www.spokey.eu