Wiring Connection - Kenwood KDC-BT950DAB Schnellstartanleitung

Removing the unit
/

Wiring connection

Fuse (10 A)
STEERING WHEEL
REMOTE INPUT
REMOTE CONT
ANT CONT
P. CONT
MUTE
ISO connectors
:
DAB antenna jack
Antenna terminal
If no connections are made, do not let
the wire come out from the tab.
NOTE: Total output for Blue/White wire
(*1) + (*2) is 12 V 350 mA
(A) Faceplate (×1)
/ :
(B) Trim plate (×1)
(C) Mounting sleeve (×1)
(D) Wiring harness (×1)
(E) Extraction key (×2)
a Light blue/yellow: To the steering wheel remote control adapter
b Blue/white: To the power control terminal when using the optional power
amplifier or to the antenna control terminal in the vehicle
c Brown: To connect the Kenwood navigation system, refer your navigation
manual
d Yellow: Battery wire
e Red: Ignition wire
f Red: A7 from ISO connector
g Yellow: A4 from ISO connector
Pin Color and function (for ISO connectors)
A4 Yellow
A5 Blue/White*1
A7 Red
A8 Black
B1, B2 Purple ], Purple/black [
Gray ], Gray/black [
B3, B4
B5, B6 White ], White/black [
B7, B8 Green ], Green/black [
Part list (supplied)
: Battery
: Power control
: Ignition (ACC)
: Earth (ground) connection
: Rear speaker (right)
: Front speaker (right)
: Front speaker (left)
: Rear speaker (left)
3