Advanced Settings; Automatic Time Setting - Bresser WIFI ClearView Weather Station 7in1 Bedienungsanleitung

7. Web browser: Internet browser that support HTML 5
Router requirements:
Wi-Fi standard 802.11 b/g/n
Supported router security type WEP, WPA, WPA2, open (for routers without password)

19 Advanced settings

1 Select 'SETUP' to enter the settings menu
3 Temperature calibration indoor/outdoor and
channel 1-7
5 Latest firmware
7 Select unit
9 Gain value for rain, wind speed, UV and light
calibration. The wind direction has a +/- 10 off-
set.

20 Automatic time setting

After the power supply and the Wi-Fi connection are established, the time and date information is
automatically transmitted by the Internet time server.
If the radio signal is received correctly, the date and time are set automatically and the reception sym-
bol is displayed.
If the time/date information was not received or not received correctly, proceed as follows:
1. In countries/regions whose time zone differs from the coordinated world time UTC, the time zone
must be set manually (see chapter 'Setting the time zone') in order to display the correct time.
2. Press the REFRESH button on the base unit for about 2 seconds to re-initiate the retrieval of Inter-
net time information.
3. Check the W-LAN settings on the base unit for correctness and correct them if necessary so that
an Internet connection can be established (see chapter 'Establishing a W-LAN connection').
14 / 32
SETTINGS
SETUP ADVANCED
1
2 Temperature o C Humidity %
Indoor
Current off set: 1 Current off set: - 5
Outdoor
Current off set: - 9 Current offset: 1 0
CH 1
Current off set: 2 Current offset: - 5
CH 2
3 Current off set: 3 Current offset: - 2
CH 3
Current off set: 1.2 Current offset: - 2
CH 4
Current off set: -0. 2 Current offset: - 5
CH 5
Current off set: -20. 1 Current offset: - 3
CH 6
Current off set: 1 1.5 Current offset: -10
CH 7
Current off set: 0.2 Current offset: - 3
Range: -20.0 ~ 20. 0 C Range: -20 ~ 20
o
-36.0 ~ 36. 0 F (Default: 0.0) (Default: 0.0 )
o
Pressure
hpa
Current off set: - 3
Absolute Pressure Of fset:
(Default: 0 )
4
Current off set: 1 0
Relative Pressure Of fset:
(Default: 0 )
Setting Range:
-560~ 560hpa / -16.54 ~ 16.54inHg / -420 ~ 420mmH g
Current gain: 0.8 5
*Rain gain:
Range: 0.5 ~ 1.5(Default: 1.00)
Current gain: 0.7 5
*Wind speed gain:
Range: 0.5 ~ 1.5(Default: 1.00)
Current off set: 2 o
*Wind direction:
Range: -10 ~ 10(Default: 0 o )
Current gain: 1.1
*UV gain:
Range: 0.01 ~ 10(Default: 1.00)
Current gain: 1.1
*Light gain:
Range: 0.01 ~ 10(Default: 1.00)
* Depends on the model
5
Firmware version: 1.00
Browse
Upload
2 Select unit
4 Pressure calibration section
6 Pressure calibration indoor/outdoor and chan-
nel 1-7
8 Enter an offset value to compensate for the
measured pressure value
10 The firmware update function only available in
PC/Mac web browser.
6
7
8
9
10