Troubleshooting - Conrad Eurosky SR 401 Bedienungsanleitung

Troubleshooting

The camera you acquired is a product which was constructed according to the cur-
rent state of the art and is safe in operation.
However, problems or trouble might arise notwithstanding this.
Therefore, we will describe for you below how to remedy possible trouble:
Do not fail to observe the safety instructions.
Trouble
The remote control
unit does not operate or are incorrectly inserted.
No sound can be
heard
No image, no sound The programm is blocked
44
Possible cause
The batteries are exhausted
The remote control unit is
held in a wrong direction
The distance of action of the
remote control unit is exceeded distance of 7 m
Direct solar radiation is incident Do not expose receiver
on the reception indicator eye
of the receiver
There is an obstacle in the path
of transmission between the
remote control unit and the set
The volume is completely
turned down on the TV set
The MUTE circuit of the set is
activated
The satellite bowl is not
oriented correctly.
There is no power supply to
the LNB, check the cable run
from receiver to LNB
Remedy
Renew batteries or insert
them correctly
Hold remote control unit
towards the indicator eye
on the receiver
Do not exceed a
to direct solar radiation
Provide a non-obstruc-
ted transmission path for
the remote control unit
Increase the volume
Disactivate MUTE circuit
by pressing the MUTE
key (19) on the remote
control unit
Note item "Turn on/off
child safety device"
Apply to an expert to get
the satellite bowl adju-
sted correctly.
Get the cable checked
by an expert or replaced,
if required