Installation; Location; Electrical Connection; Dimensions Of Housing - JUNO JCZ 94181 Gebrauchsanweisung

46 electrolux

INSTALLATION

Location

The appliance should be installed
well away from sources of heat such as
radiators, boilers, direct sunlight etc.

Electrical connection

Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply. Voltage can
vary by ±6% of the rated voltage.
For operation with different voltages, a
suitably sized auto-transformer must
be used.
The a a ppliance m m ust b b e e e arthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed, connect the appliance to
a separate earth in compliance with
current regulations, consulting a
specialist technician.
The M M anufacturer d d eclines a a ll
responsibility i i f t t he a a bove s s afety
precautions a a re n n ot o o bserved.
This appliance complies with
the following E.E.C. Directives:
• 87/308 E E EC of 2/6/87 relative to
radio interference suppression.
• 73/23 E E EC of 19.2.73 (Low Voltage
Directive) and subsequent
modifications;
• 89/336 E E EC of 3.5.89
(Electromagnetic Compatibility
Directive) and subsequent
modifications.
ATTENTION!
It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be
easily accessible after installation.
Dimensions of
housing
Height 1780 mm
Depth 550 mm
Width 560 mm
50 mm
D567
For safety reasons, minimum
ventilation must be as shown in Fig.
Attention: k k eep v v entilation o o penings
clear o o f o o bstruction.
It is necessary that the niche is
provided with a ventilation conduct
having the following dimensions:
Depth 50 mm
Width 540 mm
PR01
min.
2
200 cm
min.
200 cm
3
2
1
2