Drain Hose - AEG Electrolux Favorit 52850 Benutzerinformation

WARNING!
Make sure that the retaining nut and all other connections are tight before you move the
dishwasher into position.
WARNING!
Always use a new water inlet hose. Do not use connection hoses from an old appliance.

Drain hose

The appliance has water safety system to prevent water damage. If there is a malfunction,
the drain pump automatically starts to drain the remaining water out of the dishwasher.
WARNING!
Only if the dishwasher is connected to the mains socket, the water safety system operates
when the dishwasher is off.
2 procedures are possible to install the wa-
ter drain hose :
1. Attach the plastic curve supplied at the
end of the hose.
Put the water drain hose in the sink.
2. Connect the water drain hose to the
water drain system.
The hose must be less than 75 cm
above the bottom of the dishwasher to
prevent incorrect operation of appli-
ance.
If you connect the water drain hose to a trap spigot under
the sink, remove the plastic membrane (A). If you do not re-
move the membrane, remaining food can cause a blockage in
the drain hose spigot
Water connection
41