Werbung
ENGLISH
PRODUCT GUARANTEE:
All products purchased by consumers, as defi ned in Article 3 of the Consumer Code (Legislative Decree no. 206 of 6 September
2005 and subsequent amendments), are covered by the legal guarantee of the seller under Article 128 and subsequent
amendments of the consumer Code. In case of lack of conformity of the product, we invite the consumer to contact their dealer
within the statutory deadline.
This symbol indicates important product instructions or important safety information.
IMPORTANT:
Before you start to assemble and install the product, carefully read through all the instructions. Unpack the components and
check that nothing is missing and that there are no damaged or faulty components, remove the transparent protective fi lm.
Before you install the shower cubicle in its fi nal position, perform a test run. Run the unit for several minutes and check for water
leaks and any damage caused during transport and handling. This product should be installed by suitably skilled personnel.
N.B.: This product is designed for installation on fi nished walls and fl oors.
Warranty claims must be produced with the purchase invoice and the product assembling instructions.
The drawings and illustrations in this manual are provided for information purposes only.
The manufacturer reserves the right to make changes and improvements without prior notice.
WARNING!
Water hardness must never exceed 20° FR (french degrees).
The chlorine contained must never exceed 100 mg per litre.
Dismantling the shower valves:
In the event of the formation of lime scale and a resulting malfunctioning of the shower valves, dismantle the parts (fi g. A/B/C...).
We recommend you immerse the cartridge in normal vinegar until it is completely lime scale-free.
To ensure correct operation of the thermostatic mixer, the unit must be supplied from a boiler or a water heater providing 6 to 7
litres per minute of water at a temperature of 60/65°C.
CLEANING THE SHOWER UNIT:
CARING FOR YOUR CUBICLE
The cubicle panels are made with acrylic parts and must be cleaned using a liquid detergent and a soft cloth or sponge. Use a
good quality household liquid detergent. To prevent scale deposits, wipe dry using a chammy leather or a soft lint-free cloth
that removes stubborn deposits without leaving traces. Limescale deposits may be removed using specifi c detergent products.
To restore shine to the acrylic surface polish with an ordinary wax polish such as car wax. DO NOT USE ABRASIVE CLEANERS,
ALCOHOL OR ALCOHOL BASED PRODUCTS, ACETONE OR OTHER SOLVENTS.
TROUBLESHOOTING:
Before calling the Service Centre, check that:
• The hoses are properly connected and not kinked.
• Hot and cold water is being correctly delivered to the wall fi ttings.
• The water supply system was bled before the shower unit was installed.
• The mains power supply is reaching the steam generator and the green Power On LED on the control panel is lit.
WASTE DISPOSAL:
For the disposal of the product or its parts, follow the local regulations on matters of waste disposal. For Italy, Legislative Decree
n. 152 of April 3, 2006 will hold, and for the other EU countries, Directive 2008/98/EC.
H
H
40
CLEANIT
O
OR
2
WATER ONLY
Werbung
