Auto Power Off Setting; Advanced Network Settings; Checking Network Information; Switching Wi-Fi On And Off - Pioneer X-CM66D Bedienungsanleitung

Additional information

Auto power off setting

1 Press MENU on the remote control.
"Auto Power Down" will be displayed on the main display.
2 Press ENTER on the remote control.
3 Press / to switch auto power off setting
ON/OFF.
• Initial setting is set to ON.
Note
• When the auto power off is set to ON, "APD ON" will be
displayed on the main display.
• When the auto power off is set to OFF, "APD OFF" will
be displayed on the main display.

Advanced network settings

Checking network information

1 Press MENU on the remote control.
2 Press / until "Network INFO" is
displayed, then press ENTER.
3 Press / to select the item you want to
check and press ENTER.
Signal Strength
You can check the stability of the wireless connection.
More means a more stable connection.
• Adjust the angle of the wireless antenna according to the
connection status.
IP Address
The IP address of this unit is displayed.
MAC Address
The MAC address of this unit is displayed.
Network Type
Either wired LAN (Wired) or Wi-Fi (Wireless) is displayed.
SSID
The SSID of the connected access point will be displayed.

Switching Wi-Fi on and off

1 Press MENU on the remote control.
2 Press / until "Network Type Set" is
displayed, then press ENTER.
3 Press / to switch Wi-Fi setting ON/OFF.

Firmware Update

Checking the current software version

1 Press MENU on the remote control.
2 Press / until "Software Version" is
displayed, then press ENTER.

Updating the software

You can update the software of this unit via the network.
• Connect this unit to the network. (page 9, 11)
1 Press MENU on the remote control.
2 Press / until "Software Update" is
displayed, then press ENTER.
3 While "Network Update" is displayed, press
ENTER.
Restoring all the settings to the
defaults
Use the steps below to restore the all settings to their defaults.
1 Press Í to turn the power on.
2 Press MENU and then press / until
"Factory Reset" appears on the display.
3 Press ENTER.
"OK?" will appear.
4 Press ENTER.
• "Resetting" is displayed while the settings are being
restored. Power is turned off.
11
37
En