Herunterladen Inhalt Inhalt Diese Seite drucken

Kärcher 3770 M plus Betriebsanleitung Seite 10

Vorschau ausblenden Andere Handbücher für 3770 M plus:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

1 High-pressure outlet
2 Hanger for high-pressure hose
3 Transport bracket
4 Accessory keeper
5 Holder for connection lead
6 Connection lead
7 Coupling
8 Water connection with filter
9 Appliance switch (ON/OFF)
10 Spray gun with safety ratchet (A) and
high-pressure hose
11 Spray lance extension
12 Spray lance with pressure control
13 Detergent nozzle
14 Detergent container
15 Dirt blaster
16 Rotating cleaning brush
Unpacking the appliance
• • • • •
Please contact your dealer immediately if, on
unpacking the appliance, you discover damage
has been caused during transportation.
• • • • •
Do not simply discard the packing materials
with the house-hold waste. Take the packing
materials to the appropriate collection areas for
recycling.
Fitting the accessories
• • • • •
Connect the spray lance extension and spray
gun.
• • • • •
Push the spray lance (detergent nozzle) against
the spring into the bayonet connector of the
extension, and then rotate it through 90° until it
clicks into place.
• • • • •
Connect the high-pressure hose to the high-
pressure outlet.
1. Starting
Electrical Connection
• • • • •
See technical data of connected values.
• • • • •
Check whether the voltage shown on the rating
plate corresponds to that of the power source.
Note: If you are using an extension cable, it
should always be completely unwound from the
cable drum and have a sufficient cross-sectional
area: 10 m = 1.5 mm², 30 m = 2.5 mm²
Water Connection
• See technical data for connected values.
• Screw the coupling (supplied with the machine)
onto the inlet water connection of the machine.
• Connect a water supply hose to the machine using
a suitable hose connector to match the coupling on
the machine (hose and connector not supplied).
Suction
Observe the following if you are drawing water
from an open container:
1. Unscrew the union element from the water
connection of the appliance, and attach a suc-
tion hose with filter (order no. 4.440-570) direct-
ly to the appliance.
2. Allow the pump to operate without the high-
pressure hose until water appears at the high-
pressure outlet without any more bubbles.
3. Then re-attach the high-pressure hose.
Note:
Dirt in the feed water could lead to the appliance
being damaged. To avoid this risk, we recom-
mend fitting a filter. A suitable filter with 3/4" con-
nection is available under Order No. 4.730-059.
English
9

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis