Pioneer XW-NAw1-k Bedienungsanleitung Seite 15

Using The XW-NAW1-K
Connecting to
a video display
1. Make sure the XW-NAW1-K
and the video display device
are both turned off.
2. Connect a component video
cable (not included) to the
component video output
jacks on the bottom of the
XW-NAW1-K. Make sure you
match the color of each plug
to a jack of the same color.
3. Connect the other end of the
component video cable to an
available set of component
video input jacks on the video
display device. Make sure
you match the color of each
plug to a jack of the same
color.
4. Turn on the video source
and XW-NAW1-K. Select the
correct input on the video
source to watch the signal
from the XW-NAW1-K.
5. Select a video on your iPod
and play it.
P P Y
R B
COMPONENT VIDEO OUT
Important: Make sure the
video settings on your iPod
are adjusted correctly to watch
video on a separate display. You
might need to remove the iPod
from the XW-NAW1-K dock to
change these settings. See the
user manual that came with
your iPod for more information.
AUX IN DC IN 16V
15
En