Comet CRRC 51 ECO Anleitungen Für Montage, Gebrauch Und Wartung Seite 42

CAUTION
• This part of the manual is reserved for the
of the machine.
CAUTION
• Gloves and goggles must be worn when unpacking to prevent injury to hands and eyes.
• The machines are heavy components (also refer to the section
and it is therefore advisable to unpack them by cutting the base of the cardboard box.
• Packaging elements (plastic bags, staples, etc.) must not be left within the reach of children as they are
potential sources of danger.
• The packaging must be disposed of in accordance with the regulations in force in the country where
the machine is installed.
• Plastic packaging must not be dispersed into the environment.
• After unpacking the machine, ensure that all components are present and intact, taking care that the
identification and warning labels are present and legible. The identification label (6) of the wheelbarrow
is attached to this manual – it must be affixed to the base (9) by the
• In the event of any queries, contact the Manufacturer.
• This manual, the EVERFLO motor pump manual and the manual of the CBM module included on the
machine, the declaration of conformity and the warranty certificate must always accompany the machine
and be made available to the end user.
CAUTION
• Assembly of the machine must be carried out following the instructions contained in this manual and
good practice regarding mechanical installation. The Manufacturer's Technical Support Service is at
the disposal of the
• Check the tightness of the fittings and hose clamps.
Refer to the figures on the initial pages of this manual.
a) Attach the CBM module to the base (9) and secure it with the screws provided (fig. 9);
b) Mount the handles (7), securing them with the screws provided.
c) Using the clamps, connect one end of the suction hose (8) to the filter fitting (15) and the other end to
the pump suction fitting.
d) Connect one end of the by-pass hose (4) to the by-pass fitting (23) of the control valve and fasten the
other end to the tank fitting (3) by means of a second clamp.
e) Using the clamps, connect one end of the delivery hose (1) to the lance fitting (17) and the other end
to the delivery fitting (22) of the control valve (if a hose reel is present, refer to the following section).
f) Install the battery following the instructions in the CBM module manual in the section "BATTERY
INSTALLATION AND CHARGING"
g) Charge the battery by following the instructions in the CBM module manual in the section "BATTERY
INSTALLATION AND CHARGING"
h) Carry out a test run with pure water before delivering the machine to the end user.
i) Affix the label (6) on the base (9) according to the section
CAUTION
• Suction lines must have a nominal pressure of 5 bar (73 psi).
42
PART TWO
(for the exclusive use of the
UNPACKING
SPECIALIST TECHNICIAN
HYDRAULIC FITTINGS
SPECIALIST TECHNICIAN
SPECIALIST TECHNICIAN
"SPECIFICATIONS AND TECHNICAL DATA"
ASSEMBLY
to provide all the information required.
"
iDentifiCation anD Warning labels
)
and is not designated for the user
SPECIALIST TECHNICIAN
.
"
),
.