Battery Installation And Charging - Comet CRRC 51 ECO Anleitungen Für Montage, Gebrauch Und Wartung

- solvents and thinners of all types;
- paints of all types;
- liquids with temperatures above 40°C or below 5°C;
- liquids containing granules or solids in suspension.
• The machine must not be used for washing the following: people, animals, live electrical equipment,
delicate objects, or the machine itself.
• The accessories (standard and optional) used with the machine must be of the type approved by the
Manufacturer.
• The machine is not suitable for use:
- in special environments such as corrosive or explosive atmospheres;
- indoors, if equipped with a combustion engine.
• For use on board vehicles, ships or aircraft, contact the Manufacturer's Technical Support Service, as
additional requirements may be required.
Any other use is considered improper.
The Manufacturer cannot be held liable for any damage resulting from improper or erroneous
use.
CAUTION
• Follow the preliminary procedures contained in the manual for the EVERFLO motor pump and
the CBM module that is included on the machine.
• Check that the sprayer lance is closed: trigger (18) not pressed down (
• Check tightness of clamps that connect the hoses to their respective fittings.
• Do not use the machine when:
- the high-pressure hose, lance or safety devices are damaged;
- it has been overturned or subject to severe impact;
- there are clear signs of leakage of pumped liquid.
In the above cases, have the machine checked by a
• Have a
SPECIALIST TECHNICIAN
• Wear clothing and personal protective equipment that provides adequate protection from any high
pressure jets and chemicals used.
• Insert a sheet of paper into the sleeve (26) indicating the chemical product in use. Update the information
each time a different chemical is used. Check regularly that the information supplied is legible.
a) Check that the state of the plants or crops is such that they require treatment.
b) Carry out the preliminary procedures contained in the manual for the EVERFLO motor pump and the
CBM module that is included on the machine. In particular, remember to recharge the battery that drives
the motor pump.
c) Check that the suction filter (5) is clean and that the knob (24) is correctly engaged (refer to the
section).
"f "
ilter Cleaning
WARNING
• When using at very low temperatures, ensure that there is no ice inside the pump, hoses or tank.
Refer to the instructions contained in the CBM module manual.
34
PRELIMINARIES
carry out the checks required for non-routine maintenance.

BATTERY INSTALLATION AND CHARGING

"OFF"
SPECIALIST TECHNICIAN
position).
.