Safety Devices - Comet CRRC 51 ECO Anleitungen Für Montage, Gebrauch Und Wartung

CAUTION
• If one or more labels should become damaged during use, contact the Manufacturer or
for replacement.
TECHNICIAN
• The label (29) must be affixed by the
a) Wheelbarrow identification label.
The identification label (6) displays the wheelbarrow model, year of manufacture and the main technical
specifications, including empty weight and tank capacity.
It is located on base fig. 7 (CRRC 51 ECO on frame fig. 8).
b) CBM module identification label.
The CBM module identification label displays the model of the module, serial number, main technical
specifications, and year of manufacture. It is located on one side of the module (front of tank) in proximity
of the inlet of the supply hose.
c) Warning label.
The warning label (11) draws the user's attention to a number of hazards that may arise when using the
machine. It is located on the tank (14). The meaning of the pictograms is shown in the table below:
No smoking
a.
Read the instruction manual
b.
Do not stand within the operational range
c.
of the machine
Do not discharge waste into the environment
d.
Do not remove safety devices
e.
Do not clean and lubricate when in operation
f.
Do not drink! Non-potable water
g.
d) Label .
This appliance is marked with a symbol for separate collection of electrical and electronic equipment (WEEE).
This means that this product must be taken to a separate collection point in accordance with European
Directive 2002/96/EC in order that it can be recycled or dismantled to reduce its potential impact on the
environment.
Contact your local or regional council for further information.
Electronic products that are not separately collected are potentially harmful for the environment and
human health due to the presence of hazardous substances.
a) Pressure switch.
This device, calibrated by the Manufacturer, allows the maximum operating pressure to be limited,
preventing dangerous pressures from occurring when shutting off the delivery line or when attempting
to set pressures above maximum permitted values.
CAUTION
• The pressure switch is calibrated by the motor pump Manufacturer. Do not recalibrate.
b) Protection fuse.
This device stops operation of the motor pump in the event of overcurrent.
In the event of intervention, proceed as follows, observing the instructions given in the manual of the
32
IDENTIFICATION AND WARNING LABELS
SPECIALIST TECHNICIAN

SAFETY DEVICES

.
Toxic substances
h.
Corrosive substances
i.
Wash hands following each use
l.
Use gloves
m.
Use safety mask
n.
Use ear defenders
o.
Use protective clothing
p.
SPECIALIST