Installing The Motors - Schartec Porte 150 Anleitung

6. Installing the Motors

1. Choose the correct mounting position of the motors.
2. Check that the mounting surfaces for the brackets are level.
3. Insert the cables for the power supply to the motors.
4. Remove the 3 screws on the motor cover and remove the cover as shown in Figure 8.
5. Unlock the motor as shown in Fig. 17-20 and pull the spindle out completely.
6. Move the gate leaves to the closed position.
7. Refer to the distance "B" as determined in Figure 7. Hold the rear plate of the bracket at the intended mounting
point. Check the distances as shown in Figure 12.
Figure 8
8. If the bracket is at the point where it should be mounted, then mark the four holes. Use an 8 mm drill for this
purpose. Now secure the bracket with screws and washers.
9. Make sure the bracket is completely level.
10. The distance between the rear pivot point and the frontal pivot point is 640 mm. The distance between the
lower edge of front intake to center frontal pivot attachment is 15 mm. See Figure 12.
Figure 10
Figure 12
640mm
21
Figure 9
20
Figure 11