Installation Preparation Of Drive Arms / Motors - Schartec Porte 150 Anleitung

5. Installation preparation of drive arms / motors

Notes on use of the operator
The Porte 150 swing gate operator is designed for a maximum gate weight of 150 kg (per leaf), a maximum gate
width of 2 meters (per leaf), and a maximum gate height of 2 meters (per leaf). The opening angle is up to 110°.
These maximum values must never be exceeded.
Preparations for the motor installation
The swing gate operator must not be used with defective or sluggish gates. Make sure your door has been
serviced and properly adjusted by a knowledgeable person or professional before installation. The operator is not
intended to compensate for an already defective gate.
Check the following before installation:
1) Make sure that the gate weight and gate width do not exceed the specified maximum values of the operator.
2) Make sure that the gate construction is designed for the forces of the operator.
3) Make sure the gate leaves open and close without friction, scraping, or dragging.
4) Make sure that both gate leaves are balanced and in a horizontal plane.
5) Make sure that the surfaces and the leaves are designed for engine torque.
6) Make sure that the transmitter and receiver of the photocell are mounted on a level surface and are in proper
alignment so that they are in contact with each other.
7) Check the dimensions listed below.
Porte 150
98mm
8) Make sure that there is enough space when opening the gate leaves.
Porte 150
117mm
93mm
46mm
Min
150 mm
Figure 4
640mm
674mm
Figure 5 (Aerial View)
19
360mm