For Your Safety; Operating The Appliance - Bosch MUZ5FW1 Gebrauchsanleitung

For your safety

The accessories are suitable for the food processor MUM5... .
Follow the operating instructions for the food processor MUM5... .
This appliance is suitable for mincing and mixing raw or cooked meat,
bacon, poultry and fish. It must not be used for processing other objects or
substances.
Other applications are possible if the accessories approved by the
manufacturer are used.
, Safety instructions for this appliance
Risk of injury!
Do not reach into the feed tube, always use the pusher to add more
ingredients.
Do not attach/remove the mincer until the drive is at a standstill.
Important!
Use the mincer in the specified operating position only.
The mincer must be completely assembled before use. Never assemble
the mincer attachment on the base unit.
Overview
Please fold out the illustrated pages.
Fig. 
1 Mincer attachment
a Threaded ring
b Perforated disc (hole diameter 4.5 mm)
c Blade
d Worm gear with driver
e Locking lever
f Seal
2 Filler tray
3 Pusher
Optional accessories
4 Fruit press attachment
5 Viennese whirl attachment
6 Grater attachment
7 Perforated disc
Fig.  (hole diameter 3 mm and 6 mm)
Operating position
Protection from overload
To prevent serious damage to your appliance
if the mincer is overloaded, the driver has
a notch (predetermined breaking point).
If an overload occurs, the driver breaks instead.
However, the driver can easily be replaced.
A new driver is available from customer service.
Robert Bosch Hausgeräte GmbH
Downloaded from www.Manualslib.com manuals search engine

Unscrew fastening screw on the worm gear.

Replace driver.

Tighten fastening screw.

Operating the appliance


Thoroughly clean the mincer before using for
the first time, see "Cleaning and care".
Important information
In these instructions for use the recommended
reference values for the operating speed refer to
appliances with a 7-setting rotary switch.
For appliances with a 4-setting rotary switch
you can find the values in brackets after
the values for a 7-setting rotary switch.

Assemble mincer attachment in the indicated sequence (Fig. ). Do not fully
tighten threaded ring.
Insert seal. Note position (Fig. )!

Fig. 

Press the Release button and move
the swivel arm to position 4.

Connect mincer to the drive.
Note position of the driver (1d) with
respect to the drive. If required, turn the
driver slightly.
To do this, the threaded ring must not
be screwed tightly!
en
5