Werbung
E
Adjustments on the Dip-Switch
Dip-switch 1 - Active range
Position „ON":
Position „OFF":
Dip-switch 2 – Function cleaning stop
Position „ON":
Position „OFF":
Dip-switch 3 – Function continuous flow
Position „ON":
Position „OFF":
Dip-switch 4 – Function hygiene flushing
Position „ON":
Position „OFF":
Dip-switch 5 – Function hygiene flushing time
Position „ON":
Position „OFF":
Dip-switch 6 – Function follow-up time
Position „ON":
Position „OFF":
All functions can also be combined as desired.
Standard active range
Short active range – approx. 3 cm shorter than standard
– for very small washbasins
Cleaning stop can be set by 5 close range reflexes and
is activated for 3 min. By 5 anew close range reflexes,
the cleaning stop can be deactivated.
No cleaning stop available
Continuous flow can be set by 3 close range reflexes
and is activated for 1 min. By 3 anew close range
reflexes the continuous flow can be stopped.
If cleaning stop and continuous flow (dip-switches 2
and 3 at position ON) can be activated you can set the
cleaning stop by 5 close range reflexes first (activated
for 3 min.) and then (within 5 secs.) you can set the
continuous flow by further 3 close range reflexes for
adjusted flushing stop time. By 3 anew close range
reflexes the continuous flow can be stopped early.
If continuous flow is not activated, cleaning stop can
be deactivated by 5 close range reflexes and the tap will
change into normal function.
No continuous flow available
Hygiene flushing is activated: an automatic flushing will
be released for 10 secs. or 20 secs (depends on adjust
ment of dip-switch 5) if the tap was not used for several
hours (adjustable from 3 – 24 hours -> controller: time
interval hygiene flush)
No hygiene flushing
Hygiene flushing time is 20 secs.
(Dip-switch 4 at position ON)
Hygiene flushing time is 10 secs.
(Dip-switch 4 at position ON)
Follow-up time is 2 secs.
Follow-up time is 1 sec.
13
Werbung
