Klarstein Vulsini Bedienungsanleitung Seite 48

EN
48
Problem
No warm air is blown out.
The logs glow but there is
no flame effect.
The flame effect works but
the heating function does
not work, the glowing bed
lights up when the heating
button is pressed.
The heating function does
not work.
Possible cause
Cooling cycle
The thermostat setting
prevents the heating
function from being
activated.
The flame effect is
deactivated.
The heating function is
deactivated
The safety switch has been
activated.
Approach
Normal operation will
continue for a few minutes
before switching off.
The time depends on the
current temperature. Cold
air is blown out during
this time.
Adjust the temperature
setting so that the
thermostat is set higher
than the current room
temperature.
Press the flame button
repeatedly.
When the appliance is on,
press and hold the On/
Off button for 10 seconds.
As soon as the heating
function is reactivated, the
fire bed lights up several
times.
Turn off the power switch,
wait 15 minutes and then
turn it on again.
Check the fuse. If it is
broken, the fuse must be
replaced.