Closing The Door - Electrolux CI8001 Benutzerinformation

12 www.electrolux.com
Problem
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Temperature cannot be
set.
DEMO appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
Possible cause
The door is not closed
correctly.
The "FastFreeze func‐
tion" is switched on.
The door is not closed
correctly or the gasket is
deformed/dirty.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The "FastFreeze func‐
tion" is switched on.
The appliance is in dem‐
onstration mode.
The temperature regula‐
tor is not set correctly.
The food products' tem‐
perature is too high.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
The "FastFreeze func‐
tion" is switched on.
There is no cold air circu‐
lation in the appliance.

8.2 Closing the door

1. Clean the door gaskets.
Solution
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
Refer to "Closing the door".
Refer to "Operation" .
The compressor starts after
a period of time.
Switch off "FastFreeze func‐
tion" manually, or wait until
the function resets automati‐
cally to set the temperature.
Refer to "FastFreeze func‐
tion".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera‐
ture.
Let the food products tem‐
perature decrease to room
temperature before storage.
Defrost the appliance.
Open the door only if neces‐
sary.
Refer to "FastFreeze func‐
tion".
Make sure that there is cold
air circulation in the appli‐
ance.