Troubleshooting - Zelmer ZIR3200 Healthy Benutzerhandbuch

Troubleshooting

Problem
The iron does not heat up.
The clothes tend to stick.
Water drips out of the
soleplate when using the
shot of steam function.
Excessive dripping or
steaming.
The motor does not work.
Smoke comes out when
connecting the iron for the
first time.
Deposits come out through
the holes in the soleplate.
The appliance makes a
pumping sound.
The automatic clean
warning lamp "calc" flashes.
Possible cause
The "Sense Technology" function
has been activated. The iron is set
to stand-by.
The temperature of the soleplate
is too high.
You have pressed the shot of
steam button repeatedly without
waiting for 5 seconds between
each press.
No proper closing of "clean"
button.
1. The iron is not in a horizontal
position.
2. The soleplate is heating up.
This may be caused by the
lubrication of some of the internal
parts.
Traces of lime scale are coming
out of the steam chamber.
Water is being pumped into the
steam chamber.
The "Self-cleaning" reminder has
been activated.
Solución
Grip the handle of the iron to
re-start it.
Select a lower temperature and
wait until the iron has cooled
down.
Wait 5 seconds between each
press of the shot of steam
button.
Point the iron away from the
ironing area. Actuate a few
times the "clean" button.
1. Use the iron in a horizontal
position.
2. Wait until the selected
temperature is reached.
This is normal and will stop
after a few minutes.
Carry out a cleaning cycle
(see "Self-cleaning function"
section).
This is normal.
Carry out a cleaning cycle
(see "Self-cleaning function"
section).
EN
17