Troubleshooting - Zelmer ZIR3285 Benutzerhandbuch

All manuals and user guides at all-guides.com

Troubleshooting

Problem
Soleplate is not heating
even though iron is
turned on.
Iron does not produce
steam
Spray function does not
work
Steam jet and vertical
steam jet function does
not work
The iron is leaking
White streaks come
through the holes in the
soleplate
Possible cause
Connection problem
Temperature control is in "min"
position
Not enough water in tank
Steam control is selected in non-
steam position.
Selected temperature is lower than
that specified to use with steam.
Not enough water in tank
Steam jet function was used very
frequently within a short period.
Iron is not hot enough
The temperature setting is too low
to produce steam.
No proper closing of "calc'nClean"
system.
The soleplate has a build-up of
scale because it has not been self-
cleaned regularly.
Solution
Check main power supply cable
plug and outlet.
Select adequate temperature
Fill water tank
Set steam control between
positions of minimum steam and
maximum steam.
Select a higher temperature
Fill water tank
Put iron on horizontal position
and wait before using steam jet
function.
Adjust to higher temperature to
steam ironing. Put iron in vertical
position and wait temperature
indicator light becomes fixed.
The variable steam knob must be
set on position until the iron is
hot.
Actuate a few times the "clean"
button
Do the self-cleaning process.
Remember to do it at least every
two weeks.
EN PL
15