BEGA EHC-360E Bedienungsanleitung Seite 40

aftersales service or the shop you purchased the appliance
at 5 . Original spare parts should be used only.
When the power cord is damaged, it must be replaced by
(7)
the manufacturer or an authorised aftersales service or a
qualified professional only.
Never touch power plugs, power switches or other
(8)
electrical components with wet or damp hands. RISK OF
ELECTRIC SHOCK!
WARNING!
Operate the appliance with 220 ~ 240 V AC / 50 Hz only.
(1)
Disconnect the appliance from the mains before you clean
(2)
or maintain it.
The technical data of your energy supply must meet the
(3)
data on the rating label. The main current circuit must be
equipped with a safety shut-down device.
The appliance must always be grounded and protected
(4)
corresponding to the requirements of your local energy
supplier. The main current circuit must be equipped with a
safety shut-down device.
All modifications to the electrical mains to enable the
(5)
installation of the appliance must be performed by a
Depending on model.
5
qualified professional.
In case of an event caused by a technical malfunction,
(6)
disconnect the appliance from the mains.
Do not repair the appliance yourself. Repairs carried out by
(7)
unauthorised persons can cause serious damage. Always
contact the nearest service centre. Only original spare-
parts should be used for repairs.
Do not use adapters, multiple sockets and extension cords
(8)
for connecting the appliance to the mains.
If any cracks occur on the glass-ceramic, switch off the
(9)
appliance and disconnect it from the mains. RISK OF
ELECTRICAL SHOCK!
Do not carry out any modifications to your appliance.
(10)
The appliance is not allowed to be operated with an external
(11)
timer or a separate remote-control-system.
After use, always switch off the appliance as described in
(12)
this manual.
The room the appliance is installed in must be dry and well-
(13)
ventilated. When the appliance is installed, an easy access
to all control elements is required.
The veneering of cabinets has to be fixed with a heat-
(14)
resistant glue, that is able to withstand a temperature of 120
0 C.
Adjacent furniture or housing and all materials used for
(15)
installation must be able to resist a temperature of min. 85
40