Rear Panel - Numark NS7III Schnellstartanleitung

Rear Panel

16
19
17 18
1. NS7III Power Input: Use the included power cable to connect NS7III to a power outlet. While the
power is switched off, plug the cable into NS7III first, then plug the cable into a power outlet.
2. NS7III Power Switch: Powers NS7III on and off. Power on NS7III after all input devices have been
connected and before you turn on amplifiers. Turn off amplifiers before you turn off NS7III.
3. USB Port: Use the included small display USB cable to connect this USB port to the "NS7" USB
port on the display.
4. Power Output (DC Out): Use the included small display power cable to connect this output to
the display power input (DC In).
5. Display Power Input (DC In): Use the included small display power cable to connect this input
to the power output (DC Out) on NS7III.
6. Cable Restraint: You can secure the display power cable to this restraint to help prevent
disconnecting it accidentally.
7. Display Power Switch: Powers the display unit on and off.
8. USB Port (NS7): Use the included small display USB cable to connect this USB port to the USB
port on NS7III.
9. USB Port (USB In): You can connect an optional USB hard drive (not included) to this powered
USB port.
10. Display USB Port (To PC): Use the included USB cable to connect this USB port to your
computer.
11. Master Output (XLR): Connect this low-impedance XLR output to a PA system or powered
monitors. The level of this output is controlled with the Master knob on the top panel.
12. Master Output (RCA): Use standard RCA cables to connect this output to a speaker or amplifier
system. The level of this output is controlled by the Master knob on the top panel.
13. Booth Output (RCA): Use standard RCA cables to connect this output to a booth monitoring
system. The level of this output is controlled by the Booth knob on the top panel.
14. Line/Phono Inputs (RCA): Connect your audio sources to these inputs. These inputs can accept
both line and phono-level signals.
15. Line/Phono Switch: Flip this switch to the appropriate position, depending on the device
connected to the Line/Phono Inputs. If you are using phono-level turntables, set this switch to
Phono to provide the additional amplification needed for phono-level signals. If using a line-level
device, such as a CD player or sampler, set this switch to Line.
16. Line Inputs (RCA): Connect line-level devices, such as CD players, samplers or audio interfaces,
to these inputs.
17. Grounding Terminal: If using phono-level turntables with a grounding wire, connect the
grounding wire to these terminals. If you experience a low "hum" or "buzz", this could mean that
your turntables are not grounded.
Note: Some turntables have a grounding wire built into the RCA connection and, therefore,
nothing needs to be connected to the grounding terminal.
18. Mic 2 Input (1/4" / 6.35 mm): Connect a 1/4" (6.35 mm) microphone to this input. Microphone
controls are located on the top panel on any channel whose Input Selector is set to Mic2.
19. Motor Torque: Flip this switch to adjust the torque of the platters. At the high setting, the
platters will have the heavier, stronger feel of "modern" turntables. At the lower setting, they are
lighter and more graceful—the feel of a "classic" turntable.
20. Cooling Fan: Keep the area in front of this vent clear from obstructions. The fan behind the vent
cools the NS7III, preventing overheating.
7
6
14 14 16
3
15
4
5 8 9
10
20
1 2
11 12 13
9