Continuity Test; Diode Test - SATA 03021 Bedienungsanleitung

Note:
1. When the measured resistance is 1MΩ or more, it may take a few seconds to
obtain a stable reading, which is normal for high resistance measurement.
2. When the input terminal is open circuited, "overload" will appear.
3. Before online resistance measurement, switch off the power of the measured
circuit and fully discharge all capacitors.
f) Continuity test
1. Insert the black and red probes into the "
2. Set the function switch to "
resistance unit appears on the screen.
3. Connect the probes to the two ends of the circuit to be measured.
4. The built-in beeper sounds when the resistance is less than about 30Ω.
Note:
Before the test, switch off the power of the measured circuit and fully discharge
all capacitors.
g) Diode test
1. Insert the black and red probes into the "
probe is "+".)
2. Set the function switch to "
voltage unit appears on the screen.
3. Connect the red probe to the positive pole of the diode to be measured and the black
probe to the negative pole.
4. Read the approximation of the forward voltage drop of the measured diode indicated
on the screen.
03021
". And then press "
". And then press and hold the "
" jacks.
"and hold the button until a
" jacks. (Note: The polarity of the red
-24-
EN DE RU KO PT
" button until a
JA ES