Continuity And Diode Test; Panel Description - SATA 03021 Bedienungsanleitung

Note:
In a continuity test, the beeper may sound or not when the resistance is 30Ω~120Ω.
The beeper does not sound when the resistance is greater than 120Ω.

Panel description

1. Head
- It is used to clamp the measured conductor during current measurement. The
measured conductor shall be located in the center of head during the measurement.
2. Insulated gate
- It is used to form a protective distance at the jaw, so as to reduce the risk of fingers
touching the head or the measured conductor. When the meter is held by hand, the
fingers shall not go beyond the insulated gate.
3. Trigger
- It is used to control the opening and closing of the head.
4. Phase sequence indicator
5. Display
- 3 1/2-digit LCD, with a maximum reading of 1999 in units
6. " " jack
- Input jack of yellow probe during phase sequence test.
7. " " jack
- Input jack of black probe.
8. " " jack
- Input jack of red probe.
9. " " button
- Press and hold this button for about 2 s to turn on or off the backlight. The backlight
03021
-21-
EN DE RU KO PT
Figure 1
JA ES