Introduction - SATA 03021 Bedienungsanleitung

Introduction

This meter is a safe and reliable 3 1/2-digit digital clamp multimeter with automatic
range and stable performance. It can be used for the measurement of AC/DC voltage,
AC, resistance, diode and continuity, and the test of phase sequence. It is a practical
measurement tool, with such features as data hold, screen backlight and full-range
overload protection.
Safety information
The meter is designed to conform to Pollution Degree 2 and Overvoltage Category
CATI600V as specified in IEC-61010.
Warning
- To avoid electric shock and personal injury, please follow the following operating
requirements:
- The meter shall be used with the method specified in this manual; otherwise,
protective measures provided by the meter may be damaged.
- Do not use the meter if it is damaged. Check the casing before use, especially the
insulation around the connectors.
- Check the insulation of the probes for damage or exposed metal. Check if the
test probes are conductive. If a test probe is damaged, please replace it with a
new one for continued operation.
- If the meter is not working properly, do not use it. Its protective device may have
been damaged. If you have any doubt, the meter should be sent for repair.
- Never use the meter near explosive gases, vapors or dust.
- Never apply a voltage greater than the rated voltage indicated on the meter
between the terminals or between the ground and any terminal.
- Before use, check that the meter is working properly by measuring a known
voltage.
- Use only designated replacement parts during repair.
- Exercise caution when working with voltages above 30Vac rms, 42Vac peak or
60Vdc. These voltages pose a shock hazard.
- When using the probes, keep your fingers behind the finger guards.
03021
-15-
EN DE RU KO PT JA ES