Ac Measurement; Resistance Measurement - SATA 03021 Bedienungsanleitung

c) AC voltage measurement
1. Insert the black and red probes into the "
2. Set the function switch to "
3. Connect the probes to the two ends of the power or circuit to be measured.
4. Read the reading.
Note:
To avoid electric shock or damage to the meter, do not apply a voltage greater than
600V to the input.
d) AC measurement
1. Remove all the probes from the meter, and then set the function switch to the
required current measuring position.
2. Press the trigger, clamp the conductor to be measured with the head, and then slowly
release the trigger until the head is closed completely.
Note:
Ensure the conductor to be measured is clamped in the center of the head. The
meter can only measure one conductor at a time. If two or more conductors are
measured at the same time, a reading error will occur.
3. Read the reading indicated on the screen.
e) Resistance measurement
1. Insert the black and red probes into the "
2. Set the function switch to "
3. Connect the probes to the two ends of the resistor to be measured.
4. Read the reading indicated on the screen after it is stable.
03021
".
".
" jacks.
" jacks.
-23-
EN DE RU KO PT JA ES