Interlogix ATS7340 Installationsanleitung Seite 3

No. Name Function
3. FU Firmware upgrade
4. MFU Modem firmware upgrade
5. Reserved
LEDs
In the following LED descriptions, a flash is defined as 250 ms
on and 250 ms off. Groups of flashes are separated by 1 s off.
MI_ST (D1)
The MI_ST LED (green) displays the status of the
communication interface to the panel.
Table 2: MI_ST LED status
Rate (±10%)
Duty cycle Description
—
100% Power on (in case none of the cases
below are valid)
—
0% No power or power failure
25% 1 s Initialization OK, waiting for
communication
50% 1 s Everything OK, communication running
75% 500 ms Hardware failure
50% 250 ms Failure in communication, waiting for
reinitialization
RSSI (D2)
The RSSI LED (green) indicates the field strength or signal
strength found by the GSM module. The number of flashes
indicates the level.
Table 3: RSSI LED status
Flashes Description
Off No field strength (no network detected)
1 to 5 Field strength indication from poor (1) to excellent (5)
NET (D3)
The NET LED (green) indicates the status of the network. The
meaning of the number of flashes is described in Table 4
below.
Table 4: NET LED status
Flashes Description
Off Not registered
On Registered to home network
1 Registered to roaming network
2 Searching network
3 Denied
4 Unknown
DATA (D4)
The DATA LED (green) indicates the status of the GPRS/LTE
communication.
P/N 466-5520-ML • REV C • ISS 16DEC19
Table 5: DATA LED status
Default value
State
Off
Off
Off
On
Off
Blink
Flash
CALL (D5)
The CALL LED (yellow) indicates status of the audio
information transmitted to the central station.
Table 6: CALL LED status
Duty cycle
100%
0%
10%
50%
PSUE (D6)
The PSUE LED (red) indicates the status of the power supply.
Table 7: PSUE LED status
Duty cycle
Off
50%
On
SIME (D7)
The SIME LED (red) indicates the status of the SIM card. The
meaning of the number of flashes is indicated in Table 8 below.
Table 8: SIME LED status
Flashes
Off
1
2
3
4
5
On
HB (D8)
The HB LED (red) indicates that the device is running.
Table 9: HB LED status
Duty cycle
Off
50%
On
Description
GPRS/LTE is not available
GPRS/LTE is available, connection established
GPRS/LTE is available, connection established, sending data
GPRS/LTE is available, connection not established
Rate (±10%)
Description
—
Connected
—
Offline
1 s Connecting
1 s Ringing present
Rate (±10%)
Description
—
Power supply okay
1 s MI bus voltage low
—
Power supply problem
Description
Ready
PIN error
PUK error
PIN 2 error
PUK 2 error
SIM blocked from network
SIM not present
Rate (±10%)
Description
—
ATS7340 is not operational
1 s ATS7340 is running
—
ATS7340 is not operational
3 / 42