Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MARINE R T 30 -T40
E LEC TR I C A L CO N N EC TI O N A N D E A R TH I N G
Before connecting the plug to the mains, make sure the mains voltage corresponds to that shown
on the rating plate (located inside the cooler) and that the socket has a normal earthed system
as required by safety regulations for electrical systems. The electrical socket must also be able to
support the maximum power loading of the appliance indicated on the plate itself.
WARNING!
If the socket is not fitted with an earthed system or if multiple sockets or adapters are used, the
manufacturer shall not be liable for any injuries to persons or damage to property and/or the cooler
itself.
WARNING!
The user must always be able to access the plug.
US E
When connecting the plug to the mains outlet, the cooler starts operating immediately, unless the
temperature adjusting knob is set to "0" (zero)" (see figure 03).
TE M PE R ATU R E S E T TI N G
The knob for the temperature adjusting thermostat is located in the upper part of the internal liner
of the refrigerator.
To set the internal temperature, adjust the control knob according to the ambient temperature or
based on the use the refrigerator is intended to.
The temperature control range is comprised of the following levels:
•
position 0 = refrigerator off
•
position 1 = minimal refrigeration (higher internal temperature)
•
position 2 = medium refrigeration (intermediate internal temperature)
•
position 3 = maximum refrigeration (lower internal temperature)
In the niche versions, the door can be hooked onto the leaf of the cabinet housing through the
drawing line which allows for simultaneous opening (dragging system). If the door opens in the
opposite direction from the leaf of the cabinet, proceed as follows (see figure 04):
•
remove the protection A that covers the upper plate B;
•
unscrew the screws fastening the plate B to the refrigerator structure and remove that plate;
•
unscrew the foot C and the screws fastening the lower plate D, and remove that plate;
•
remove the protection E and the foot F;
•
assemble the lower plate D and the foot C in a position opposite to the previous one;
•
assemble the upper plate B and its protection A in a position opposite to the previous one;
•
assemble the protection E and the foot F in a position opposite to the previous one;
•
put the plate A back using the relevant screws.
A PPLY I N G TH E D R A F T
(see figure 05)
The draft is a device - consisting of two parts, A and B - which connects the door of the cooler to the
door of the piece of furniture it is fitted into, both when opening and when closing.
To install the draft, proceed as follows:
•
screw the part A onto the door of the cooler;
•
open the door of the cooler by 90°;
Mariner T30-T40_(220V)_IM_20190313
10
Werbung
Inhaltsverzeichnis
