Care And Cleaning - Vitamix TurboBlend Two Speed Bedienungsanleitung

Container
To prepare your new machine for initial use, follow the steps under Normal Cleaning below. This will clean
the unit, and break-in the motor.
Normal Cleaning:
1. Fill the container half full with warm water and add a couple drops of liquid dish washing detergent to the
container.
2. Snap or push the complete 2-Part lid into locked position.
3. Start with the High/Low Switch in the Low ( ) position. Activate the machine by switching the On/Off
Switch to On (|). The machine will start on Low then switch the High/Low Switch to High ( ).
4. Run the machine on High for 30 to 60 seconds.
5. Turn off the machine, and rinse and drain the container.
To Sanitize:
1. Follow Normal Cleaning instructions above.
2. Fill the container half full with water and 1 1/2 teaspoons of liquid bleach.
3. Snap or push the complete 2-Part lid into locked position.
4. Start with the High/Low Switch in the Low ( ) position. Activate the machine by switching the On/Off
Switch to On (|). The machine will start on Low then switch the High/Low Switch to High ( ).
5. Run the machine on High for 30 to 60 seconds.
6. Turn off the machine, and allow mixture to stand in the container for an additional 1 1/2 minutes.
7. Pour bleach mixture out. Allow container to air dry.
8. Do not rinse after sanitizing.
Lid, Lid Plug and Tamper
Separate the lid and lid plug. Wash the parts in warm soapy water. Rinse clean under running water, and
dry. Reassemble before use.
IMPORTANT: To ensure continued and effective performance, do not put the container, lid, lid plug or
tamper in the dishwasher.
40
C A R E A N D C L E A N I N G