Labels Supplied With The Accessories Bag; Installation; Connection Cable; Before The Installation - Electrolux EHF3920BOK Benutzerinformation

20 www.electrolux.com
7.3 Labels supplied with the
accessories bag
Stick the adhesive labels as indicated
below:
A. Stick it on Guarantee Card and send
B. Stick it on Guarantee Card and keep

8. INSTALLATION

8.1 Before the installation

Before you install the hob, write down the
information bellow from the rating plate.
The rating plate is on the bottom of the
hob.

8.2 Built-in hobs

Only use the built-in hobs after you
assemble the hob into correct built-in
units and work surfaces that align to the
standards.
Downloaded from www.Manualslib.com
A B
MOD. MOD.
PROD.NO. PROD.NO.
SER.NO SER.NO
DATA DATA
this part (if applicable).
this part (if applicable).
WARNING!
Refer to Safety chapters.
Model .......................................
PNC .........................................
Serial number ...........................
manuals search engine
C
MOD.
PROD.NO.
SER.NO.
0049
03 IT
MADE IN ITALY
C. Stick it on instruction booklet.

8.3 Connection cable

• The hob is supplied with a connection
cable.
• To replace the damaged mains cable
use the following (or higher) mains
cable type: H05V2V2-F T min 90°C.
Speak to your local Service Centre.
8.4 Attaching the seal
1. Clean the worktop around the cut out
area.
2. Attach the supplied seal stripe to the
lower edge of the hob along the outer
edge of the glass ceramic. Do not
extend it. Make sure that the ends of
the seal stripe are located in the
middle of one side of the hob.
3. Add some mm when you cut the seal
stripe to the length.
TYPE
IP20