Cleaning And Maintenance; Troubleshooting - TaoTronics TT-BH092 Bedienungsanleitung

When paired successfully,
tap and hold the Touch
Turn On / Off
Control on either of the
Voice Control
earbuds for 2 seconds until a
beep is heard
Clear Pairing Refer to the "Clear Pairing
List List" section
Go into Pairing
Refer to the "Pairing" section
Mode
Successfully
/
paired with
your device
Bluetooth out
of Range /
/
Failed to pair
with your device
Note: Only when you are wearing the earbuds can you hear the voice prompt.

CLEANING AND MAINTENANCE

1. Clean the earbuds and the charging case on a regular basis.
2. Use dry and soft cotton cloth to wipe the unit.
Note: Do not insert anything into the product.
3. Keep away from sharp objects to avoid scratches.
4. Put the unit in a dry and shady place if it is to be idle for a long time.
5. Do not clean the product with detergent or chemicals.
09
Toot
/
Pairing
Connected
Disconnected

TROUBLESHOOTING

No. Problem Solution
Failed to turn on the
Earbuds low battery, please charge them
1
earbuds
• Place the earbuds into the charging
Failed to charge the
case properly
earbuds
2
• Make sure the charging case is charged fully
Can't charge the Make sure the charging cable is intact
3
charging case and plugged in properly
The earbuds reconnected with previously
paired device automatically:
• Deactivate the Bluetooth function of
Can't find
previously paired device or clear
"TAOTRONICS
4
"TAOTRONICS SoundLiberty 92" from
SoundLiberty 92" in the
its Bluetooth device list, and then
Bluetooth device list
search again
• Put the device to be connected close to
the earbuds
• Turn on the device and activate its
Failed to pair the
5
Bluetooth function before pairing
earbuds with your
• Bring the earbuds into pairing mode
device
as instructed in the "Pairing" section
Place both earbuds back to the charging
case then take them out, they will pair
No sound in one of the
6
with each other automatically. If pairing
earbuds in couple
failed, restore them back to the factory
earbuds mode
settings as instructed in the "Clear Pairing
List" section
10